BACA-HVAC
23 Kulick Rd
Fairfield, NJ 07004
ph: 973-575-7577
fax: 973-575-4111
CHRIS
Rx11-flush is an ozone-safe solvent engineered specifically for flushing refrigeration and air conditioning systems. Used exactly like the old R-11 flushing process, Rx11 is strong enough to rinse away particulate, sludge, carbon residues, acids, oils and water. It enhances system service and avoids the need for time-consuming repeat visits. Rx11-flush should become an Integral part of standard procedures for any major system repair, oil change-out or retrofit.
Enter Rx11-flush, pioneered by the same chemists who produced the original Rx11. Rx11-flush offers all of the benefits of R-11 without the environmental concerns. This is a totally new chemical formulation based on new HFC technologies. It is a powerful cleaner, stronger than R-11 ever was, and it is the best prescription to effectively scrub the inside of the refrigeration system. It dries quickly, has a low boiling point (106oF), has no aroma, will not attack components, offers great worker safety ratings and is affordable priced. Rx11-flush is the industry’s best answer for major system overhauls.
R22 to R410a
FOR R-410A CONVERSIONS
- Use Rx11-flush to clean line sets. This is especially beneficial when converting from R-22 to R410A. Establish one end of the line set as the injection point. Th other end of the line set will be the exit point. Provide for some restriction at the exit point as this will provide for longer contact time and better cleaning. Inject the Rx11-flush in to the line set.
Approximate amount of Rx 11-flush for flushing line set
Using the compressed nitrogen tank, connect the nitrogen tank to the system and inject it into the system behind the Rx11-flush. The nitrogen will increase the mass flow and maximize the cleaning power of the Rx11-flush. Pull a vacuum on the line set, and continue the conversion1/2" tubing1 each 2 lb. canisterPer 100'3/4' tubing2 each 2 lb. canisterPer 100'
- Use Rx11-flush to clean line sets. This is especially beneficial when converting from R-22 to R410A. Establish one end of the line set as the injection point. Th other end of the line set will be the exit point. Provide for some restriction at the exit point as this will provide for longer contact time and better cleaning. Inject the Rx11-flush in to the line set.
HOW TO:
Click the canister for instructions onHow to flush your lineset!!
23 Kulick Rd
Fairfield, NJ 07004
ph: 973-575-7577
fax: 973-575-4111
CHRIS
